Power switch for your Raspberry Pi with soft shutdown function The SHIM (Shove Hardware in the Middle) board is only 1 mm thick (without assembly) and can be plugged directly between the Raspberry Pi and a shield onto the GPIO pins and soldered or can be plugged onto the GPIO with the solderable adapter. Use Simply plug your micro USB power adapter into the Micro-B port on the OnOff SHIM, then press the button once to turn on the power and start your Pi. Once you have installed the software, you can press the button again to initiate a clean shutdown and completely interrupt the power supply of your Pi. Properties • 1 mm thin printed circuit board (without components) • Can be used with hats and pHats • Corner button for on/off • Micro-B connector for power supply • Red status LED • Optional breakout pins for connecting an external button • 2x 6 socket connector included • Supports up to 2.5 a power supply • Clean shutdown software (downloadable) • must be soldered Software As soon as the button is pressed, the software initiates a clean shutdown and then completely disconnects the Pi from the power supply. To install the software, open a terminal and tap curl https://get.pimoroni.com/onoffshim | bashto run the one-line installer. Supplied without Raspberry Pi and without housing Note Although it is possible to use OnOff SHIM and a 2.5 a USB Micro B power supply to power a Raspberry Pi 4, the recommended current specification for the Pi 4 is 3 amps. Especially when using USB devices, there may be problems with the power supply. https://elecena.pl/product/18408575/0704256800864-raspberry-pi-shield-onoff-shim 2021-05-09 https://elecena.pl/product/18408575/0704256800864-raspberry-pi-shield-onoff-shim 2024-02-12