410-370 Development board Cora Z7: Zynq-7000 single core, Z7-07S

Cora Z7: Zynq-7000 Single Core for ARM/FPGA SoC Development (Cora Z7-07S)

Description: The Digilent Cora Z7 is a ready-to-use, low-cost, and easily embeddable development platform designed around the powerful Zynq-7000 All-Programmable System-on-Chip (APSoC) from Xilinx. The Zynq-7000 architecture tightly integrates a single or dual core 667MHz ARM Cortex-A9 processor with a Xilinx 7-series FPGA. This pairing grants the ability to surround the processor with a unique set of software-defined peripherals and controllers, tailored for the target application. The Cora Z7’s wide array of hardware interfaces, from a 1Gbps Ethernet PHY to analog-to-digital converters and general-purpose input/output pins, make it an ideal platform for the development of a vast variety of embedded applications. The small form factor and mounting holes make the Cora Z7 ready to be used as one component of a larger solution. The on-board SD Card slot, Ethernet, and Power solution allow the Cora Z7 to operate independently of a host computer.

Features: ZYNQ Processor - 667MHz dual-core (*single-core) Cortex-A9 processor - FPGA Programmable logic equivalent to Artix-7 FPGA - 4,400 Programmable logic slices (*3,600) - 80 DSP slices (*60) - 270 KB of block RAM (*225 KB) - DDR3 memory controller with 8 DMA channels and 4 High Performance AXI3 Slave ports - High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO - Low-bandwidth peripheral controllers: SPI, UART, CAN, I2C - Dual-channel, 1 MSPS internal analog-digital converter - Programmable from JTAG and microSD card

Memory - 512MB DDR3 with 16-bit bus @ 1050Mbps - microSD slot

Power - Powered from USB or any 4.5V-5.5V external power source

USB and Ethernet - Gigabit Ethernet PHY with 48-bit globally unique EUI-48/64™ compatible identifier available on sticker - USB-JTAG programming circuitry - USB-UART bridge - USB OTG PHY (supports host only)

Push-buttons and LEDs - Two Push-buttons - Two RGB LEDs

Expansion Connectors - Two Pmod connectors - 16 Total FPGA I/O - Arduino/chipKIT Shield connector - Up to 49 Total FPGA Digital I/O - 6 Single-ended 0-3.3V Analog inputs to XADC - 8 Differential 0-1.0V Analog inputs to XADC - Unloaded expansion header - 12 additional FPGA Digital I/O

What's Included: - Cora Z7-07S or Cora Z7-10 - Custom Digilent cardboard box with protective foam inserts