Stop fiddling with SD card sockets in the back of your latest gadget, and streeeeeeeeeetch out with a Micro SD Card Extender. Note: Not compatible with the Raspberry Pi 4 or Pi 5. The Pi 4/5 use a lower voltage SD interface, which seems to cause issues when using extenders like these. The forum post link above suggests a hack where you can remove the resistor on the extender to get this working, however this will invalidate your warranty. This simple, but effective device gives you a long flexible cable, a psuedo Micro SD card on one end, and a matching micro SD card socket on the other. Plug in the card half and attach the socket wherever you like. This is a great hack for length constraints with 3D printers, single-board computers, data-logging kits and more. Get to your micro SD card in and out and safeguard against wear and tear. The sockets are push-push. Insert the card in to lock, and press in again to release it. There's a wee pictogram on the socket which shows the correct orientation. We used this with a Replicator 3D printer (using an adapter), various Feathers, and also a Raspberry Pi 3 Linux computer and it was speedy and error-free, but it is a hack, so be aware that high-speed and high-noise environments may end up not working. Note: Micro SD Card not included. Technical Details * Cable Length: 68cm * Product Weight: 10.2g https://elecena.pl/product/22715854/micro-sd-card-extender-68cm 2023-03-07 https://elecena.pl/product/22715854/micro-sd-card-extender-68cm 2023-12-27 https://elecena.pl/product/22715854/micro-sd-card-extender-68cm 2024-09-19 https://elecena.pl/product/22715854/micro-sd-card-extender-68cm 2024-11-29 https://elecena.pl/product/22715854/micro-sd-card-extender-68cm 2024-11-30 https://elecena.pl/product/22715854/micro-sd-card-extender-68cm 2025-11-28 https://elecena.pl/product/22715854/micro-sd-card-extender-68cm 2025-11-29