This CAN Bus module enables long-range CAN Bus communication with your Raspberry Pi Pico via UART. The board uses an EBYTE E810-TTL-CAN01 CAN-Bus module which features operating and status LED indicators. The board also includes TX/RX indicators, a resistor config selector and power/UART selector pads (solder). Online development resources are available, which include wiring guidance and example code, with additional information being found on the Waveshare Wiki. Note: Raspberry Pi Pico not included. You'll need a Pico with male headers soldered to it. You can grab a Pico here and Pico male headers here, or buy a Pico with pre-soldered headers. Features * Designed for Raspberry Pi Pico * Incorporates E810-TTL-CAN01 module, UART to CAN bus conversion * Three conversion methods: * Transparent conversion * Transparent conversion with identification * Protocol mode conversion * Online development resources and manual Specifications * Operating Voltage: 3.3 V * Communication Bus: UART * Can Transceiver: E810-TTL-CAN01 * Baudrate: 300~921600bps * Dimensions: 58.00 x 25.00mm What's On Board * 1) E810-TTL-CAN01 module * 2) Module operating indicator * 3) Module status indicator * Operating mode: blinking at 1Hz frequency * Command configuration mode: blinking at 5Hz frequency * 4) TX/RX indicators * 5) Resistor config * ON: connected to 120R matching resistor * OFF: disconnected from 120R matching resistor (default) * 6) CAN bus terminal * 7) Power supply selection * 8) UART selection Package Contents * 1x CAN Bus Module for Pico Raspberry Pi Pico not included Resources * Waveshare Wiki Pinout Definition https://elecena.pl/product/22724123/can-bus-module-for-raspberry-pi-pico-discontinued 2023-03-07 https://elecena.pl/product/22724123/can-bus-module-for-raspberry-pi-pico-discontinued 2024-09-19