The Servo:Lite board for the BBC micro:bit is a simple board that allows you to easily connect and control low power servo motors (servo's must be capable of operating at 3.3V) using the BBC micro:bit. It is connected to the micro:bit using five bolts. Connect two servos in standard configuration and it can drive up to 3 servos if the addressable 'ZIP' LEDs aren’t needed. It is powered by 3 AAA batteries and also supplies power to the BBC micro:bit, the board features an On / off switch so when it's not in use the batteries won't drain. The board also features 5 x RGB individually addressable ZIP LEDs (NeoPixel compatible) and additional external ZIP LEDs can be connected to the board as required. Kitronik have produced a range of tutorials and guides that can be found in the resources section below. With have guides detailing; how to control a third servo and how to write code for the on-board ZIP LEDs. Features: * Connect two servos in standard con?guration and can drive up to 3 servos if the addressable 'ZIP' LEDs aren’t needed. * Powered by 3 AAA batteries that also supply power to the BBC microbit (not supplied). * On / off switch. * 5 x RGB addressable ZIP LEDs (NeoPixel compatible). Additional external ZIP LEDs can be connected to the board. Contents: * 1 x Servo:Lite board with battery holder pre-fitted. * 5 x M3x8 Counter sunk Pozi Steel screws. * 1 x Perspex spacer. Dimensions: * Length: 55mm. * Width: 52mm. * Height: 17mm.