The ADL5358 uses a highly linear, doubly balanced, passive mixer core along with integrated RF and local oscillator (LO) balancing circuitry to allow single-ended operation. The ADL5358 incorporates the RF baluns, allowing for optimal performance over a 500 MHz to 1700 MHz RF input frequency range. Performance is optimized for RF frequencies from 500 MHz to 1200 MHz using a high-side LO and RF frequencies from 1200 MHz to 1700 MHz using a low-side LO. The balanced passive mixer arrangement provides good LO-to-RF leakage, typically better than −20 dBm, and excellent intermodulation performance. The balanced mixer core also provides extremely high input linearity, allowing the device to be used in demanding cellular applications where in-band blocking signals may otherwise result in the degradation of dynamic performance. A high linearity IF buffer amplifier follows the passive mixer core to yield a typical power conversion gain of 8.3 dB and can be used with a wide range of output impedances. The ADL5358 provides two switched LO paths that can be used in TDD applications where it is desirable to ping-pong between two local oscillators. LO current can be externally set using a resistor to minimize dc current commensurate with the desired level of performance. For low voltage applications, the ADL5358 is capable of operation at voltages down to 3.3 V with substantially reduced current. Under low voltage operation, an additional logic pin is provided to power down (<300 µA) the circuit when desired. The ADL5358 is fabricated using a BiCMOS high performance IC process. The device is available in a 6 mm × 6 mm, 36-lead LFCSP and operates over a −40°C to +85°C temperature range. An evaluation board is also available. Applications * Cellular base station receivers * Transmit observation receivers * Radio link downconverters * RF frequency range of 500 MHz to 1700 MHz * IF frequency range of 30 MHz to 450 MHz * Power conversion gain: 8.3 dB * SSB noise figure of 9.9 dB * SSB noise figure with 5 dBm blocker of 23 dB * Input IP3 of 25.2 dBm * Input P1dB of 10.6 dBm * Typical LO drive of 0 dBm * Single-ended, 50 Ω RF and LO input ports * High isolation SPDT LO input switch * Single-supply operation: 3.3 V to 5 V * Exposed paddle, 6 mm × 6 mm, 36-lead LFCSP