MKDGH8-01 Wet room distribution box, 1-row, 8 modules

Wet room distributor for the highest demands The fuse boxes of the DISBOX-F series have a degree of protection IP65 and are therefore ideally suited for use in damp rooms. The surface-mounted damp room distributor is made of high-quality acrylester-stirene-acrylonitrile (ASA) and is therefore more weather-resistant than conventional ABS housings. The high impact resistance and degree of protection IP65 of the fuse box ensure that all fuses and residual current circuit breakers within the distributor are protected against all environmental influences in dry and damp rooms. All fuse boxes in this range are equipped with transparent doors, which allows a visual inspection of the fittings without opening the door.

Metric pre-stamping and flange knockouts for optimized cable routing The damp room distributors of the DISBOX-F series are equipped with metric pre-stamping and, depending on the size, also with pre-stamping for flange plate outbreaks in the lower part of the housing. These allow cable glands or cable glands to be installed in the housing without much effort. This significantly reduces the assembly effort without damaging the housing wall and causing chip formation. Depending on the housing type, different metric pre-stamping is available, often 2 different sizes can be broken out depending on the requirements.

Injected rubber seal for optimum protection in the damp room The requirements of the DISBOX-F series are an increased degree of protection (IP65) for the use of distribution boxes in damp rooms. The wet room or wet room is a concept from the construction industry. Standards and technical regulations make special demands on materials and construction methods intended for use in damp rooms. A damp room is defined differently depending on the area of expertise: