Adafruit MACROPAD RP2040 Bare Bones - 3x4 Keys + Encoder + OLED

Want to add more hardware? No worries - a STEMMA QT port on the side lets you connect any I2C add-on peripherals from the massive STEMMA QT / Qwiic family of plugin boards.Please note, this board does have basic QMK support! However, it's very early and not everything is supported, e.g the OLED screen. This macropad is designed to be programmed in Arduino or CircuitPythonTL;DR?Raspberry Pi RP2040 Chip + 8MB Flash memory - Dual-core Cortex M0+ at ~130MHz with 264KB, or RAM. Runs CircuitPython, Arduino, or MicroPython with ease and lots of space for development code and filesUSB C Connector for Power/Data - of course, this can act as an HID device but also can be MIDI, UART, etc.3x4 Mechanical key switch sockets - accepts any Cherry MX-compatible switches. Individually tied to GPIO pins (not matrix wired)One NeoPixel RGB LED per switch, on north sideRotary encoder, 20 detents per rotation, with push-switch on GPIO pin. Push switch is also used for entering bootloader mode when held down on power-up or reset.128x64 SH1106 Monochrome OLED display - On high-speed hardware SPI port for quick updates8mm Speaker/Buzzer - With Class D amplifier and RC filter, can be used to make simple beeps and sounds effects.STEMMA QT Connector - Allows adding any I2C sensors/displays/devices with plug-and-play cables.Reset button - On the side, for quick restarting of codeFour M3 mounting bosses - Make custom enclosures easily