3.3V, E1/T1/J1, Short-Haul, Octal Line Interface Unit

The DS26303 is an 8-channel short-haul line interface unit (LIU) that supports E1/T1/J1 from a single 3.3V power supply. A wide variety of applications are supported through internal termination or external termination. A single bill of material can support E1/T1/J1 with minimum external components. Redundancy is supported through nonintrusive monitoring, optimal high-impedance modes, and configurable 1:1 or 1+1 backup enhancements. An on-chip synthesizer generates the E1/T1/J1 clock rates by a single master clock input of various frequencies. Two clock output references are also offered.

Applications

* ATM and Frame Relay Equipment * E1/T1/J1 LAN/WAN Routers * E1/T1/J1 Multiplexer and Channel Banks * ISDN Primary Rate Interface * T1 Digital Cross-Connects * Wireless Base Stations

* 8 Complete E1, T1, or J1 Short-Haul Line Interface Units

* Independent E1, T1, or J1 Selections

* Internal Software-Selectable Transmit and Receive-Side Termination

* Crystal-Less Jitter Attenuator

* Selectable Single-Rail and Dual-Rail Mode and AMI or HDB3/B8ZS Line Encoding and Decoding

* Detection and Generation of AIS

* Digital/Analog Loss-of-Signal Detection as per T1.231, G.775, and ETS 300 233

* External Master Clock can be Multiple of 2.048MHz or 1.544MHz for T1/J1 or E1 Operation; This Clock will be Internally Adapted for T1 or E1 Use

* Built-In BERT Tester for Diagnostics

* 8-Bit Parallel Interface Support for Intel or Motorola Mode or a 4-Wire Serial Interface

* Hardware Mode Interface Support

* Transmit Short-Circuit Protection

* G.772 Nonintrusive Monitoring

* Specification Compliance to the Latest T1 and E1 Standards—ANSI T1.102, AT&T Pub 62411, T1.231, T1.403, ITU-T G.703, G.742, G.775, G.823, ETS 300 166, and ETS 300 233

* Single 3.3V Supply with 5V Tolerant I/O

* JTAG Boundary Scan as per IEEE 1149.1

* 144-Pin eLQFP Package