Raspberry Pi Compute Module 4/5 Antenna Kit

The official external antenna for your Compute Module 5 or 4. Certified for use with Raspberry Pi Compute Module 4 and Raspberry Pi Compute Module 5. Note: CM4 and IO board not included. Specifications

* Frequency range: 2400-2500/5100-5800 MHz

* Bandwidth: 100–700MHz

* VSWR: ≤ 2.0

* Gain: 2 dBi

* Impedance: 50 ohm

* Polarisation: Vertical

* Radiation: Omnidirectional

* Maximum power: 10W

* Connector: SMA (female)

* Antenna dimensions: 108 mm × 10 mm

* Shell material: ABS

* Installation: Screw

* Operating Temperature: -35 to +75°C

* Weight: ± 3 g

Resources

* Raspberry Pi Compute Module 4/5 Antenna Kit product brief

* Product number: Raspberry Pi SC0480

* EAN: 728886755189

Fitting Instructions

* Connect the U.FL connector on the cable to the U.FL-compatible connector on Compute Module

* Screw the toothed washer onto the SMA (male) connector on the cable, then insert this SMA connector through a hole (e.g. 6.4 mm) in the end-product mounting panel

* Screw the SMA connector into place with the retaining hexagonal nut and washer

* Screw the SMA (female) connector on the antenna onto the SMA (male) connector which now protrudes through the mounting panel

* Adjust the antenna to its final position by turning it through up to 90°, as shown in the illustration below

* To use the Antenna with your Compute Module, add a dtoverlay instruction in /boot/firmware/config.txt. Add the following line to the end of config.txt: dtparam=ant2

Compliance The Raspberry Pi Compute Module 4/5 Antenna Kit has undergone extensive compliance testing and meets the standards required in many countries. You can find all compliance information and regional certificates at raspberrypi.org/compliance.