1.27" RGB OLED Display Module (128x96, 262K Colours)

This OLED display might be small at just 1.27", but the folks at Waveshare have managed to pack a 128x96 resolution into the panel, along with 262K colours. This makes it great for making a tiny data display, and unlike traditional greyscale/one-colour OLEDs, you can use pretty much any colours you like to bring that information to life - be it from a weather API, 3D printer status, robotics feedback or any other data you want to throw at it. The module uses an SSD1351 driver with SPI for communication (4-wire by default). This minimises your pin usage, keeping your GPIO for sensors and other components you want to feed this display with. The package comes with a matching 7-pin cable with female header ends, ready to plug into your microcontroller's GPIO pins. Demo code is provided for the Raspberry Pi and Arduino. Note: the display ships with 4-wire SPI mode enabled by default. Changing the mode to 3-wire SPI requires careful desoldering and movement of the small SMT resistors on the rear (not for beginners!). Connection Example - Raspberry Pi

Connection Example - Arduino

Features

* 1.27" RGB OLED display

* 262K colours

* 128x96 pixels

* Operating voltage: 3.3V/5V

* Support interface: 4-wire SPI, 3-wire SPI (4-wire by default, SMT soldering required to change)

* Controller: SSD1351

* Resolution: 128(H)RGB x 96(V)

* Dimension: 25.708mm x 19.28mm

* Pixel size: 0.047mm x 0.185mm

Resources

* Product Wiki

Pinout

Pin/label Description

VCC Power input

GND Ground

DIN Data input

SCL Clock input

CS Chip select, active low

DC Data/command signal selection: - Low level indicates a command - High level indicates data

RST Reset signal, active low

Package Contents

* 1x 1.27" RGB OLED Module

* 1x 7-pin GH1.25 cable