Arduino UNO compatible starter kit for learning programming for beginners

The Programming Learning Kit is a complete starter kit that includes the ATMEGA328 R3 CH340 module. The kit also includes a USB A/B cable, a 1-channel relay, and two types of cables of 10 each: Male-Female and Male-Male.. In addition, the kit includes an active buzzer, 4 large Tact Switches, 15 LEDs in three colours. For light measurement, there aretwo photoresistors. Sound experiments are made possible by a sensor with a built-in comparator.. The kit also offers a 7-segment digital display with a common cathode, a 10k Ohm NTC thermistor for temperature measurements, a DC 2.1/5.5 male connector with a 9V battery connector, a 1x40pin pin strip and various (1/4W 1K, 10K, 220R) resistors of 10 each type. All these elements make this kit an ideal tool for learning and experimenting with electronics. Here are some examples of projects that can be realised using this kit:

* Alarm System: Using a relay, sound sensor, LEDs and buzzer, you can build a simple alarm system that activates a light and sound signal when it detects sound or movement

* Weather station: Using thermistors to measure temperature and photoresistors to monitor light levels, a basic weather station can be built to record changes in weather conditions

* Light Level Indicator: Using photoresistors and an LED display, a device can be created to measure and display the intensity of light in the environment

* Simple Sound Synthesiser: Using a buzzer and Tact Switch, it is possible to build a simple device that generates different sounds depending on the buttons pressed

* Directional traffic lights: Using LEDs, it is possible to simulate the operation of traffic lights by programming different light sequences

* Interactive Projects: By combining different sensors and outputs, such as LEDs, buttons and sound sensors, you can create interactive projects that respond to different stimuli from the environment

Specification:

* ATMEGA328 R3 CH340 chip: Arduino UNO compatible, soldered microcontroller

* Prototype contact plate: 400 fields

* USB A/B cable 1m

* 1-channel relay

* 10x 20cm jumpers: Male-Female

* 10x 20cm jumpers: Male-to-Male

* Active buzzer

* B10k potentiometer

* 4x Tact Switch large

* LEDs: 5x Green, 5x Blue, 5x Red

* RGB LED

* Tilt sensor

* 2x Photoresist

* Sound Sensor Module with comparator

* Display 1 Digital 7 Segment: Common cathode

* NTC thermistor 10k Ohm 5%

* Male connector DC 2.1/5.5: plug with conetor for 9V batteries

* Pinned strip: 1x40pin

* 1/4W 1K resistor: 10pcs

* 1/4W 10K resistor: 10pcs

* Resistor 1/4W 220R: 10pcs