DFRobot Gravity: I2C BMI160 6-Axis Inertial Motion Sensor

The BMI160 6-axis inertial motion sensor is a new product from DFRobot. It is based on Bosch BMI160 6-axis MEMS sensor which integrates 16-bit 3-axis accelerometer with ultra-low-power 3-axis gyroscope. Bosch BMI160 is designed for smartphones, tablets, wearable devices. It has built-in intelligent step-counting algorithms that can be read directly through registers. Built-in 3-axis acceleration and 3-axis gyroscope can detect running, fitness and other motion. Built-in LDO power management chip, supports 3.2~6V wide voltage power supply, and also has I2C level conversion circuit, compatible with Arduino 3.3V and 5V micro controller.

Features

* Step Count * Acceleration Detection * Inclination Measurement * Display Toggle Horizontal / Vertical Mode Specifications

* Operating Voltage: 3.2V~6V * Current Consumption: <1mA * Interface: Gravity-I2C * Acceleration Range: ±2g/±4g/±8g/±16g * Gyroscopes Range: ±125°/s,±250°/s,±500°/s,±1000°/s,±2000°/s * Acceleration Zero-g Offset: ±40mg * Gyroscopes Zero-g Offset: ±10°/s * Programmable Frequency: 25/32Hz~1600Hz * 6D Detection and Location * 16-bit Data Output * Shock Resistance: 1000gx 200us * 2 Independent Programmable Interrupt Generators * In-built 1024 Byte FIFO * Working Temperature:-40℃~+85℃ * Dimension: 22X27mm/0.87x1.06 in Documents

* Product wiki * More Documents Shipping list

* Gravity: I2C BMI160 6-axis IMU x1 * Gravity I2C/UART sensor cable x1 * XH2.54 Single Row Pin Header-4P x1 Projects

* Project 1. A Wristband Pedometer Based on BMI160 Motion Sensor Recently I bought a 6-Axis Inertial Motion Sensor from DFRobot. So it occurs to me that why not make a wristband pedometer to calculate my physical strength. * Project 2. Light of Earth - A BMI160 gyroscope accelerometer based 3D Printing Lamp A light can be turned on by knocking on the table.