Automotive, 80V, synchronous buck controller with constant current and constant voltage with I2C | RGY | 19 | -40 to 150

The LM5192-Q1 is an80V, high-efficiency,

synchronous buck controller with constant-current constant-voltage (CC-CV)

regulation and I2C interface.

The current-mode control architecture

with a 25ns typical minimum on-time allows high conversion ratios at high

frequencies coupled with a fast transient response and excellent load and line

regulation. The highly accurate CC-CV operation enables seamless transition between

constant-current and constant-voltage modes. The I2C interface allows

programming of output voltage in 10mV or 20mV steps, average output current limit in

50mA to 200mA steps, as well as output voltage slew rate, switching frequency,

soft-start slew rate, mode of operation, current loop compensation, output active

discharge strength, and cable drop compensation gain.

The LM5192-Q1 also features an array of safety features including

undervoltage and overvoltage protection with programmable thresholds, overcurrent

protection with programmable hiccup mode, and thermal shutdown.

Additional features of the LM5192-Q1 include programmable diode emulation (PFM)

for lower current consumption at light-load conditions, open-drain nINT flag for

fault reporting and output monitoring, precision enable input, monotonic start-up into prebiased load, integrated dual input

(VIN and VOUTF) VCC supply regulator, and oversized VDDA regulator for powering

external loads, such as companion microcontrollers.

The LM5192-Q1 includes several features to simplify compliance with CISPR 25 Class 5 emissions requirements. First, an I2C programmable

switching frequency as high as 2.2MHz can be synchronized to an external clock

source to eliminate beat frequencies in noise-sensitive applications. Second,

the LM5192-Q1 has an I2C selectable ±5%

dual-random spread spectrum (DRSS) that significantly reduces peak emissions

through a combination of triangular and pseudo-random modulation while keeping

output voltage ripple very low.

The LM5192-Q1 controller comes in a 3.5mm × 4.5mm thermally-optimized, 19-pin

VQFN package. The large PGND die-attach pad improves thermal performance and board

level reliability (BLR). Also included are wettable-flank pins to facilitate optical

inspection during manufacturing. The 19-pin VQFN packaging with usable current,

lifetime reliability, and cost advantages targets applications requiring high power

density. The wide input voltage range, low quiescent current consumption,

high-temperature operation, cycle-by-cycle current limit, low EMI signature, and

small design size provide an excellent point-of-load regulator design for

applications requiring enhanced robustness and durability.