CC Debugger

CC Debugger CC Debugger debugger oraz programator dla SOC z serii CCxxxx opartych na rdzeniu 8051 produkowanych przez Texas Instruments. Programator jest zgodny z oryginalnym TI CC Debuggerem. In addition, CC Debugger is used for configuring the CC85xx devices with PurePath Wireless Configurator.

Key Features CC Debugger

* Performance

* Compatible with the original TI CC Debugger

* Supported Operating Systems: Windows 2000, Windows xp sp2/sp3, Windows Vista 32bit, Windows 7 32bit

* Target voltage: 1.2V～3.6V

* Capable of powering the target board from the debugger

* Operating temperature: 0℃～85℃

* Supported Software

* IAR Embedded Workbench For C8051

* SmartRF Flash Programmer

* SmartRF Studio

* SmartRF Packet Sniffer

* PurePath Wireless Configurator

* Connects to PC

* Computer connection via USB interface

* Connects to target board

* Target board connection via 10-pin IDC connector (2x5 2.54mm pitch). The figure below shows the header pinout:

Supported Devices

* Programming and debugging the following 8051-based system-on-chips from Texas Instruments:

* CC1110, CC1111

* CC2430, CC2431

* CC2510, CC2511

* CC2530, CC2531, CC2533

* CC2540, CC2541

* CC2543, CC2544, CC2545

* Controlling the following transceivers from SmartRF Studio:

* CC1120, CC1121, CC1125, CC1175

* CC1101, CC110L, CC113L, CC115L

* CC2520

* Configuring the CC85xx devices with PurePath Wireless Configurator:

* CC8520, CC8521

* CC8530, CC8531

LED Status

* OFF: The debugger has no power or there is no valid firmware on the debugger.

* AMBER (BOTH LEDS ON): The debugger is powered, but there is no valid firmware.

* RED LED BLINKING: The Debugger is in Boot Recovery Mode.

* RED LED ON: No device detected. This might be due to old firmware on the CC Debugger, or a problem with the hardware connection (make sure the target board is properly powered and connected correctly).

* GREEN LED ON: The target device has been properly detected. It is possible to start programming/debugging.

Package Contains

* CC Debugger × 1

* USB cable × 1

* 10-pin flat cable × 1

* User Guide CD × 1

Downloads Development resources:user manual, schematic, firmware, software, etc. Wiki: http://www.waveshare.com/wiki/CCDebugger