STLINK-V3SET In-Circuit-Programmer / Debugger for STM32 + STM8

STLINK-V3SET debugger/programmer for STM8 and STM32

Introduction The STLINK-V3SET is a stand-alone modular debugging and programming probe for the STM8 and STM32 microcontrollers. This product is composed of the main module and the complementary adapter board. It supports the SWIM and JTAG/SWD interfaces for the communication with any STM8 or STM32 microcontroller located on an application board. The STLINK-V3SET provides a Virtual COM port interface allowing the host PC to communicate with the target microcontroller through one UART. It also provides bridge interfaces to several communication protocols allowing, for instance, the programming of the target through the bootloader. The STLINK-V3SET can provide a second Virtual COM port interface allowing the host PC to communicate with the target microcontroller through another UART (called bridge UART). Bridge UART signals, including optional RTS and CTS, are available on the adapter board only (MB1440). The second Virtual COM port activation is done through a reversible firmware update, which also disables the mass storage interface (used for Drag-and-drop flash programming). The modular architecture of STLINK-V3SET enables to extend its main features through additional modules such as the adapter board.

Features - Stand-alone probe with modular extensions - Self-powered through a USB connector (Micro-B) - USB 2.0 high-speed compatible interface - Direct firmware update support (DFU) - JTAG / serial wire debugging (SWD) specific features: - 3 V to 3.6 V application voltage support and 5 V tolerant inputs - Flat cables STDC14 to MIPI10 / STDC14 / MIPI20 (connectors with 1.27 mm pitch) - JTAG communication support - SWD and serial wire viewer (SWV) communication support - SWIM specific features (only available with adapter board MB1440): - 1.65 V to 5.5 V application voltage support - SWIM header (2.54 mm pitch) - SWIM low-speed and high-speed modes support - Virtual COM port (VCP) specific features: - 3 V to 3.6 V application voltage support on the UART interface and 5 V tolerant inputs - VCP frequency up to 15 MHz - Available on STDC14 debug connector (not available on MIPI10) - Multi-path bridge USB to SPI/UART/I2C/CAN/GPIOs specific features: - 3 V to 3.6 V application voltage support and 5 V tolerant inputs - Signals available on adapter board only (MB1440) - Drag-and-drop flash programming of binary files - Two-color LEDs: communication, power

Note: The STLINK-V3SET product does not provide power supply to the target application.

General information The STLINK-V3SET embeds an STM32 32-bit microcontroller based on the Arm® Cortex®-M processor.

System requirements - Windows® OS (7, 8 and 10), Linux® 64-bit, or macOS®(a) - USB Type-A to Micro-B cable