12V Time Relay 0-999 min. Cycle Switch - Timer - with Housing

Electronic switch module in a housing with a timer that performs switching on or off with a delay. The module is equipped with a LED display and 3 control buttons. The timer can perform the following functions: time relay, timer, a relay with a timer, a delayed activation system, timer switch, delay switch module, a system with a countdown of the activation time. Specification: electronic module: relay with a countdown timer time adjustment range: 1 second to 999 minutes module supply voltage: 12V DC LED display maximum load of the relay contacts: 10A / 250V AC (if we connect an electric device powered with 230V to the output, its maximum power cannot exceed 2300W) two relay output circuits (changeover relay): NC - normal close - normally closed circuit NO - normal open - circuit normally open lifetime of the relay about 100,000 operations ARK connectors for screwing on the wires power consumption: approx. 20mA, relay off approx. 50mA, relay is on dimensions of the plastic housing: 70mm x 40mm x 23mm Technical data: Power supply: 12V Trigger: 12V Time range: 0-999 minutes Working in the temperature range: -40-85C Dimensions: 62mm * 38mm * 19mm Relay 10A 230V-AC 30V-DC Instruction: K1 button - left K2 button - middle K3 button - right Time setting: ► Press the K2 button until the selected digit starts flashing ► use the K3 button to set the correct figure. Switching to the next digit takes place after pressing the K2 button again ► a blinking LED means the selection of time units 000 - time counted in full seconds 000. - time counted in minutes To enter the settings menu, press and hold the K1 button (buttons description is visible after opening the housing) Programs: ► program P-1 - After triggering, the relay will switch on for the set time. channel C - activates the relay and resets the counter during the countdown. Channel E - activates the relay and stops the counter during the countdown during the countdown. Channel A - activates the relay. Re-entering the signal during the countdown does nothing ► P-2 program - After triggering, the module will start counting the set time and then activate the relay for the set time channel E - The program works once after powering up (it starts immediately), to restart the timer, power the module again channel A - The program works after giving the signal , after the countdown is over, giving the signal again starts the measurement again C channel - The program works after giving the signal, re-giving the signal restarts the program (even during the countdown) ► program P-3 - the relay will operate in a loop, the time of switching on and pause can be freely set The program starts immediately after supplying the power, giving the signal changes the relay's operating mode and resets the counter ► P-4 program - After triggering, the relay will turn on for the set time, during the countdown, another signal will restart the counter