USB to CAN Adapter

This USB to CAN adapter allows you to view, analyse and control data from your CAN Bus network via your PC (Windows/Linux/Raspberry Pi). The adapter supports CAN2.0A (standard frame) and CAN2.0B (extended frame) with a configurable baud rate in the range of 5Kbps-1Mbps. It supports four working modes: normal mode, loopback mode, silent mode and silent loopback mode, as well as multiple data sending and receiving modes - alongside a host of other features (see full list below in the features section). On the adapter itself, you'll find TX/RX and power indicator LEDs alongside a reset button and 120-ohm resistor switch. The screw terminal block is removable for easy installation. The package also includes a USB extension cable and a screwdriver.

Hardware Features

1) TX Indicator - Blinks when CAN is sending data 2) PWR Indicator - Power indicator (lights when USB is connected) 3) RX Indicator - Blinks when CAN is receiving data 4) Reset Button - Press before power on then release to restore factory settings 5) 120-ohm resistor switch - Switch to CAN terminal side to enable Features

* Supports CAN2.0A (standard frame) and CAN2.0B (extended frame)

* CAN baud rate is configurable in the range of 5Kbps-1Mbps

* Supports 4 working modes: normal mode, loopback mode, silent mode, silent loopback mode

* Supports multiple CAN data sending modes: single frame, multiple frames, manually, regularly and cyclic sending

* Supports multiple CAN data receiving modes: can be configured to only receive data from a certain ID, or specify ID to automatically answer the configured data

* Data can be saved as TXT or Excel

* Supports CAN bus detection for status checking

* Sending/receiving CAN data with timescale, allows sequentially displaying

* Baud rate of USB virtual COM port is configurable in the range of 9600 ~ 2000000bps (2000000bps by default)

* Supports setting working parameters by configuration software or serial command, can be saved after power off

* Adopts STM32 chip solution

* Onboard TVS (Transient Voltage Suppressor), effectively suppress surge voltage and transient spike voltage in the circuit

* Comes with master computer software for Windows system, easy to use

* Easy secondary development, just need to modify the sending and receiving commands

Resources

* Product Wiki

Package Contents

* 1x USB to CAN Adapter

* 1x USB Cable ~1.5m

* 1x Screwdriver