PYNQ™ Z2 board - based on Xilinx Zynq C7Z020 SoC

TUL PYNQ™-Z2 board, based on Xilinx Zynq SoC is designed for the Xilinx University Program to support PYNQ (Python Productivity for Zynq) framework and embedded systems development. PYNQ is an open-source project from Xilinx® that makes it easy to design embedded systems with Xilinx Zynq® Systems on Chips (SoCs). Using the Python language and libraries, designers can exploit the benefits of programmable logic and microprocessors in Zynq to build more capable and exciting embedded systems. ZYNQ XC7Z020-1CLG400C 650MHz dual-core Cortex-A9 processor DDR3 memory controller with 8 DMA channels and 4 High-Performance AXI3 Slave ports High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO Low-bandwidth peripheral controller: SPI, UART, CAN, I2C Programmable from JTAG, Quad-SPI flash, and MicroSD card Programmable logic equivalent to Artix-7 FPGA 13,300 logic slices, each with four 6-input LUTs and 8 flip-flops 630 KB of fast block RAM 4 clock management tiles, each with a phase locked loop (PLL) and mixed-mode clock manager (MMCM) 220 DSP slices On-chip analog-to-digital converter (XADC) Memory 512MB DDR3 with 16-bit bus @ 1050Mbps 16MB Quad-SPI Flash with factory programmed 48-bit globally unique EUI-48/64™ compatible identifier MicroSD slot Power Powered from USB or 7V-15V external power source USB and Ethernet Gigabit Ethernet PHY Micro USB-JTAG Programming circuitry Micro USB-UART bridge USB 2.0 OTG PHY (supports host only) Audio and Video HDMI sink port (input) HDMI source port (output) I2S interface with 24bit DAC with 3.5mm TRRS jack Line-in with 3.5mm jack Switches, Push-buttons, and LEDs 4 push-buttons 2 slide switches 4 LEDs 2 RGB LEDs Expansion Connectors Two standard Pmod ports 16 Total FPGA I/O (8 shared pins with Raspberry Pi connector) Arduino Shield connector 24 Total FPGA I/O 6 Single-ended 0-3.3V Analog inputs to XADC Raspberry Pi connector 28 Total FPGA I/O (8 shared pins with Pmod A port)