2.15" E-Paper Quad Colour HAT+ for Raspberry Pi (296 x 160)

This 2.15" e-Paper HAT is a quad-colour display (Red/Yellow/Black/White) with no backlight, and retains the last displayed image for long periods even when powered off, making it very energy-efficient. Power is only needed during refreshes, meaning power consumption is at a minimal level. The display also has a wide 170° viewing angle for clear visibility from different areas of viewing. It also has a standard Raspberry Pi 40-pin GPIO extension header, making it compatible with Raspberry Pi series boards. The SPI connection allows it to work with other controller boards like Arduino and STM32, while a built-in voltage translator provides compatibility with both 3.3V and 5V MCUs. Included are online development resources and a manual, which makes it easy to get started! We also have a Tri-Colour version here If you're looking for the Raw display version, click here to find it in our store. Note: Raspberry Pi is NOT included Features

* No backlight, keeps displaying last content for a long time even when powered down

* Ultra-low power consumption, basically power is only required for refreshing

* Comes with online development resources and manual (driver board circuit diagram, examples for Raspberry Pi / Jetson Nano / RDK X3 / Arduino / STM32)

* Standard Raspberry Pi 40-pin GPIO extension header, supports Raspberry Pi series boards, Jetson Nano, RDK X3

* Raspberry Pi HAT+ standard to improve interoperability, helping the users to design and develop faster, easy to use with other peripherals and extend more functions for Raspberry Pi

* SPI interface for connecting with controller boards like Raspberry Pi / Arduino / STM32, etc.

* Voltage translator, compatible with 3.3V / 5V MCUs

Specifications

Operating Voltage 3.3V/5V

Interface 3-wire SPI, 4-wire SPI

Outline Dimensions 65 x 34 (mm)

Display size 48.10 x 26 (mm)

Dot Pitch 0.1625 x 0.1625 (mm)

Resolution 296 x 160 pixels

Display Colours Red/Yellow/Black/White

Greyscale 2

Full Refresh Time 20s

Refresh Power <50mW

Standby Current <0.01uA (almost none)

Viewing Angle >170°

Connection Example - Raspberry Pi Zero

Raspberry Pi Zero is NOT included Resources

* Product Wiki

* Schematic

Pinout

VCC Power (3.3V / 5V input)

GND Ground

DIN SPI MOSI pin

CLK SPI SCK pin

CS SPI chip selection, low active

DC Data/Command selection (high for data, low for command)

RST External reset, low active

BUSY Busy status output pin

Package Contents

* 1x 2.15" e-Paper HAT+

* 1x GH1.25 9-pin cable

* 1x Screw pack