PIC18F6722-I/PT 8-bit PICmicro microcontroller, 128 KB, 40 MHz, TQFP-64

PIC18F6722 Family, 64-Pin, 1-Mbit, Enhanced Flash Microcontrollers with 10-Bit A/D and nanoWatt Technology

Special Microcontroller Features: - C Compiler Optimized Architecture - 100,000 Erase/Write Cycle Enhanced Flash Program Memory Typical - 1,000,000 Erase/Write Cycle Data EEPROM Memory Typical - Flash/Data EEPROM Retention: 100 Years Typical - Self-Programmable under Software Control - Priority Levels for Interrupts - 8 x 8 Single-Cycle Hardware Multiplier - Extended Watchdog Timer (WDT): Programmable period from 4 ms to 131s - Single-Supply 5V In-Circuit Serial Programming™ (ICSP™) via Two Pins - In-Circuit Debug (ICD) via Two Pins - Wide Operating Voltage Range: 2.0V to 5.5V - Programmable Brown-out Reset (BOR) with Software Enable Option

Power Management Features: - Run: CPU On, Peripherals On - Idle: CPU Off, Peripherals On - Sleep: CPU Off, Peripherals Off - Ultra Low 50 nA Input Leakage - Run mode Currents Down to 25 µA Typical - Idle mode Currents Down to 6.8 µA Typical - Sleep mode Current Down to 120 nA Typical - Timer1 Oscillator: 900 nA, 32 kHz, 2V - Watchdog Timer: 1.6 µA, 2V Typical - Two-Speed Oscillator Start-up

Flexible Oscillator Structure: - Four Crystal modes, up to 40 MHz - 4x Phase Lock Loop (PLL) - Available for Crystal and Internal Oscillators - Internal Oscillator Block: - Fast wake from Sleep and Idle, 1 µs typical - Provides a complete range of clock speeds from 31 kHz to 32 MHz when used with PLL - User-tunable to compensate for frequency drift - Secondary oscillator using Timer1 @ 32 kHz - Fail-Safe Clock Monitor: Allows for safe shutdown if peripheral clock stops

Peripheral Highlights: - High-Current Sink/Source 25 mA/25 mA - Three Programmable External Interrupts - Four Input Change Interrupts - Up to 2 Capture/Compare/PWM (CCP) modules - Master Synchronous Serial Port (MSSP) module Supporting 3-Wire SPI (all 4 modes) and I2C™ Master and Slave modes - Enhanced Addressable USART module: - Supports RS-485, RS-232 and LIN/J2602 - RS-232 operation using internal oscillator block (no external crystal required) - 10-Bit, up to 13-Channel Analog-to-Digital (A/D) Converter module: - Conversion available during Sleep - Dual Analog Comparators with Input Multiplexing - Programmable 16-Level High/Low-Voltage Detection (HLVD) module