DFRobot RS485 Shield for Arduino

Arduino RS485 is an industrial standard for long distance, anti-interference and reliable communication. So we create this RS485 Arduino shield, especially designed for the Arduino controller board. It converts UART/Serial protocol to RS485 protocol. This RS485 board allows Arduino access to industrial standard protocol easily.In contrast to RS-422, which has a single driver circuit which cannot be switched off, RS-485 drivers use three-state logic allowing individual transmitters to be deactivated. This allows RS-485 to implement linear bus topologies using only two wires. The equipment located along a set of RS-485 wires are interchangeably called nodes, stations or devices.

* Integrated a standard RS485 port, a mini RS485 port, RS485 headers * Provide the welding areas to make full use of the free space. And more importantly, it's convenient for your DIY design. * Switch between automatic mode and manual transmission mode, which expand the scope of application. * Besides Tx/Rx interface, there is a switch to block/disable this shield, when Arduino needs to be programmed. * Gold immersion PCB. Long pins on the back adapt to most Arduino controllers. What is RS485?"RS-485 enables the configuration of inexpensive local networks and multidrop communications links. It offers data transmission speeds of 35 Mbit/s for distances up to 10 m and 100 kbit/s up to 1200 m. Since it uses a differential balanced line over twisted pair (like RS-422), it can span relatively large distances up to 1,200 m (4,000 ft). A rule of thumb is that the speed in bit/s multiplied by the length in meters should not exceed 108. Thus a 50 meter cable should not signal faster than 2 Mbit/s." From Wiki. Specifications

* Power module: +5V * Module size: 55mmx53mm(2.16"x2.08") * 16 digital IO port (including a I2C interface) * 6 analog IO port and power * Operation and programming mode switch * Automatic and manual transceiver mode switch (When in manual transceiver mode, the enable end is the 2nd digital IO port) * Transceiver indicating LED * Standard RS485 interface, mini RS485 interface and RS485 pins * Welding area * Reset switch * PH2.0 sensor interface for DFRobot RS485 series sensor: URM04 Ultrasonic sensor Documents

* Wiki (Arduino RS485 Shield)